iPhone 15 Screen Replacement Guide
📦 Get Your Repair Kit First
You'll need these parts to fix your iPhone 15:
As an Amazon Associate we earn from qualifying purchases. This costs you nothing extra and helps keep this site free.
⚡ Protect Your Screen — Cheaper Than Repair
A quality case + screen protector is 5% the cost of one screen replacement.
Survives 6-foot concrete drops — saves you a $200+ screen bill
9H tempered glass — first line of defense against cracks
Microfiber + brush + alcohol wipes
64 bits, pro-grade — for serious DIY repair only
The iPhone 15 is one of the easiest iPhones to repair! With affordable LCD screens and straightforward disassembly, this is a great first repair project. Follow this guide to replace your cracked screen while keeping Touch ID working.
📱 iPhone 15 Display Specifications
- Display: 4.7-inch Retina HD LCD
- Resolution: 1334 x 750 pixels, 326 ppi
- Features: True Tone, Wide color (P3), 3D Touch
- Biometrics: Touch ID (home button)
- Frame: Aerospace-grade aluminum
- Back: Glass (wireless charging)
- Release: September 2017
🛠️ Tools Required
- Pentalobe P2 screwdriver
- Tri-point Y000 screwdriver
- Phillips #000 screwdriver
- Suction cup
- Plastic opening picks
- Spudger
- Tweezers
- Hair dryer or heat gun (optional but helpful)
📦 Parts Needed
- iPhone 15 LCD Screen Assembly - $30-60
- Display adhesive (usually included)
📋 Step-by-Step Instructions
Step 1: Power Off & Remove Screws
Power off your iPhone 15 completely. Remove the two pentalobe screws on either side of the Lightning port.
Step 2: Heat Edges (Optional)
The iPhone 15 has waterproof adhesive around the screen. Applying gentle heat makes opening easier. Use a hair dryer on the edges for 1-2 minutes.
Step 3: Create Opening Gap
Apply suction cup to the lower third of the screen (above home button). Pull up firmly while pressing down on the frame to create a small gap.
Step 4: Open From LEFT Side
Insert an opening pick and slide along the left edge, then around the other edges.
Step 5: Open Display
Swing the display open from the left side to about 90 degrees. Support it so it doesn't fall back.
Step 6: Disconnect Battery
Remove the 4 tri-point screws from the battery connector bracket. Lift bracket and disconnect battery with spudger.
Step 7: Disconnect Display
Remove the 5 screws from the display cable bracket. Disconnect:
- Front sensor assembly (top connector)
- LCD panel connector (middle)
- Digitizer connector (bottom)
Step 8: Remove Home Button
The Touch ID home button MUST be transferred to your new screen:
- Remove the bracket screws holding the home button
- Disconnect the home button cable
- Carefully peel the home button from the display
Step 9: Transfer Components
Move to new screen (if not pre-installed):
- Home button (Touch ID) - REQUIRED
- Earpiece speaker
- Front camera assembly
- Metal shield plates
Step 10: Install New Screen
Connect display cables. Reconnect battery. Test before sealing:
- Screen displays properly
- Touch works everywhere
- Touch ID recognizes fingerprint
- Home button clicks properly
Step 11: Seal & Finish
Apply adhesive around edge. Close display, press firmly around perimeter. Replace bottom screws.
✅ Testing Checklist
- ☐ Display works, no dead pixels
- ☐ Touch responsive across entire screen
- ☐ Touch ID unlocks phone
- ☐ Home button clicks and responds
- ☐ 3D Touch/Haptic Touch works
- ☐ Front camera takes photos
- ☐ Earpiece speaker works (make call)
- ☐ Proximity sensor works (screen off during calls)
- ☐ True Tone active
Need Professional Help?
iPhone 15 repairs are straightforward but Touch ID is delicate. Our technicians can complete this repair with guaranteed results.
Get Pro Help →📚 Related Guides
📦 Mail-In Repair Service
Not comfortable doing this yourself? Send your device to a professional repair shop.
🛒 Recommended Products
The #1 repair kit — 64 bits, pro tools, lifetime warranty
EZ Fit tray — foolproof install, 9H tempered glass 2-pack
Charge iPhone, Watch & AirPods — one compact cube